While scraping a textured ceiling is a common tactic to achieve a flat ceiling, Mauro suggests that in some cases, it’s a lot easier to smooth over the texture with joint compound than to scrape it off. Mauro recommends a flat, white paint for the ceiling. After the sanding, the ceiling will be ready for paint.After 24 hours, lightly sand the ceiling using 220-grit sandpaper.It shouldn’t take more than two to three coats. Repeat this process until all the low spots are filled in and the ceiling is flat.Wait roughly 45 minutes for the first coat to dry.This technique requires multiple coats, so don’t feel the need to fill in all the low spots on the first pass. Scoop a small amount of the joint compound off the hawk using the taping knife, and then apply it in thin, smooth coats over the textured ceiling. Mix the joint compound in a bucket using water and the drill with a mixing bit on it until it’s roughly thicker than a cake batter consistency.Wipe down the ceiling with a damp rag to ensure it’s clean.It isn’t necessary to cover the entire wall, just the top third. Start by protecting the entire room with drop cloths.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |